Lanier Printer Accessories DF 4 User Manual

Lanier Worldwide, Inc.  
2300 Parklake Dr., N. E.  
Atlanta, GA 30345-2979  
Emergency Telephone: (800)526-4371  
MATERIAL SAFETY DATA SHEET  
Section 1: Chemical Product and Company Information  
Identity:  
Product ID: 117- 0235  
MSDS No.  
Issued: 12/16/97  
7214 Black Toner  
CP-310  
Supersedes:  
none  
Synonyms  
& Common  
Date:  
12/16/97  
Names:  
Toner, Black Toner  
Prepared by:  
Lanier QA/EH&S Department  
Uses:  
M7214 Copier  
Mixture  
European  
Contact:  
Lanier Worldwide, WSM Europe,  
Walter Fricke,  
Im Taubental D-41468 Neuss,  
Germany +49-2131-387-177  
Chemical  
Formula:  
Section 2: Composition / Information on Ingredients  
PERCENT  
CAS No.  
29497-14-1  
EXPOSURE LIMITS  
SOURCE  
Styrene butylacrylate-  
butylmethaacrylate  
copolymer  
not listed  
n/a  
> 90.0  
Polystyrene  
Carbon black  
Polypropylene  
Organic ammonium salt  
9003-53-6  
1333-86-4  
9003-07-0  
102561-46-6  
not listed  
n/a  
3.5mg/m3 3.5mg/m3  
OSHA PEL ACGIH TLV  
< 6.0  
< 1.0  
< 2.0  
not listed  
not listed  
n/a  
n/a  
*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)  
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)  
Section 3: Hazards Identification  
Hazard Rating:  
FIRE = 1  
HEALTH = 1  
REACTIVITY = 0  
SPECIAL = none  
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to  
any non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.  
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test  
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human  
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight  
degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung  
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test  
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function  
properly in xerographic equipment.  
Section 4: First Aid Measures  
Remove to fresh air if effects occur. Consult  
local medical personnel  
Inhalation:  
Eye Contact: In case of contact, immediately flush eyes with  
water for 5 minutes.  
Ingestion: Rinse mouth with water. Call a physician.  
Skin Contact:  
Wash with soap and water.  
1
 

Kustom Stereo Amplifier Sienna30 User Manual
Learning Resources Model Vehicle LER 0343 User Manual
Lightolier Indoor Furnishings 1101FRD User Manual
Lindy Mouse 20599 User Manual
Linksys Network Card NSLU2 User Manual
Makita Planer 1805B User Manual
Makita Power Hammer HR2450FT User Manual
Meco Gas Grill 67A4T09K21 User Manual
Mellerware Iron 23250 User Manual
Memorex Portable CD Player MKS2420 User Manual