Metra Electronics PDAs Smartphones 99 6540 User Manual

KIT FEATURES  
5
6
A
B
Shaft and  
DIN unit  
provisions  
"A"  
99-6540  
INSTALLATION  
INSTRUCTIONS  
C
D
KIT COMPONENTS  
ing  
A) Strip wire ends back ½"  
B) Twist ends together  
C) Solder  
D) Tape  
APPLICATIONS  
Locate the factory wiring harness in the  
dash. Metra recommends using the  
proper mating adaptor and making  
connections as shown. (Isolate and  
individually tape off the ends of any  
unused wires to prevent electrical short  
circuit).  
Locate the upper dash tab in the sub-dash and  
bend the tab down.("A")  
CAR  
DODGE  
PAGE  
Faceplate  
Van (full size) 1990-97.............................................1-3  
7
(3) 3/8" Phillips  
Screws  
TOOLS REQUIRED  
Phillips screwdriver  
Cutting tool  
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit  
assembly to the sub-dash with (2) screws. Place the Faceplate into the dash trim bezel and  
mount with(3) 3/8" Phillips screwssupplied.  
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION  
Drill  
rev. 100103  
3
 

Learning Resources Baby Toy LER 3661 User Manual
LG Electronics Car Satellite TV System 26LT670H User Manual
Lincoln Electric Welder SVM141 A User Manual
Lindy Network Card 70963 User Manual
Little Wonder Edger 6232 User Manual
Lowrance electronic GPS Receiver GlobalMap 100 User Manual
McCulloch Brush Cutter MAC 250 B User Manual
McIntosh Speaker XR27 User Manual
Metra Electronics Guitar 95 7951 User Manual
Microtek Projector CX6 User Manual