M O D E L N O . A C 8 T C
I N S T R U C T I O N S A N D W A R R A N T Y
TWIRL AND CURL™
SPIRAL CURLING IRON
13. Do not place the heated Curling Iron directly on any surface while it is
hot or plugged in. Use the stand provided.
14. While emitting steam, this Curling Iron may cause burns if it is used too
close to the skin, scalp, or eyes, or if it is used incorrectly.
15. To reduce the risk of contact with hot water emitted form steam vents,
test Curling Iron before each use by holding it away from body and
operating the steam button.
16. Do not operate this appliance with a voltage converter.
17. Before plugging in, read the information about dual voltage contained in
the instruction section of this manual.
SAVE THESE INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY
THIS PRODUCT SHOULD NOT BE USED BY CHILDREN
THE IRON IS NOT A TOY
CAUTION: This product can burn eyes
2
Getting To Know
Your TWIRL AND CURL™
Spiral Curling Iron
Diagram B
Reservoir
With Plug
(P/N 50432)
Diagram A
Polarized Plug
This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug is intended to fit into a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do
not attempt to defeat this safety feature.
3
INSTRUCTIONS
FOR USE
DUAL VOLTAGE
This appliance utilizes a positive
temperature coefficient (PTC)
heating element and operates over
a range of voltages.
Diagram C
Confirm the voltage available at
each location before using the
appliance.
4. Fill the Reservoir with tap water.
Do not use any water other than
tap or distilled water, otherwise
malfunctioning may result.
For connection to a 240-volt supply
or above, use an attachment plug
adaptor (not included) of the
proper configuration for the power
supply receptacle.
Wipe off any spilled water
before attaching the Reservoir.
5. Insert the Reservoir Plug back
into the Reservoir. Align the Plug
Tabs between the Reservoir
Slots. Push down, twist and
secure into place.
USING THE RESERVOIR
Fill the Reservoir with water before
using the Iron
Caution: The Reservoir Plug area is
very hot immediately after use.
Let it cool down before filling.
Refer to Diagram B.
6. Replace the Reservoir inside the
top of the Iron. ALign the
Reservoir Tabs with the slots
inside the Iron. Push down and
trun clockwise until it stops.
Refer to the reverse of
To Fill:
1. Turn the Reservoir
counterclockwise while pushing
it into the Iron, separating it
from the rest of the unit.
Refer to Diagram C.
Diagram C.
2. Remove the Reservoir Plug from
the Reservoir by turning and
HEATING THE IRON
1. Insert the plug into a an AC
electrical outlet.
pulling out. Refer to Diagram B.
3. Dampen the felt on the inside of
the cap with tap water for
5 - 6 seconds. Be sure to
dampen the felt of the cap
thoroughly before use. Steam
will not flow out well if the
felt is dry.
2. Slide the Power Switch to ON
indicated by the “1”.
3. When the Heat-Ready Dot
changes from red to black, the
Iron is ready to use. It will take
approximately three minutes for
the Heat-Ready Dot to change.
4
4. To prepare the Iron for steam,
Press the Reservoir down 3-4
times to allow steam to flow
through the Iron. The steam
may not always be visible under
normal conditions of use. If you
hear a hissing sound, steam is
being released.
7. Press the Reservoir to make
steam. Thicker hair might need
two or three presses.
Caution: Do not leave the Iron near
plastic, easily melted or flammable
materials while the Barrel is hot.
Diagram D
USING THE IRON
Use only on dry hair.
For better curl control, it is
recommended to add a styling
mousse or styling spray to towel
dried hair. Thoroughly dry the hair
and proceed with curling.
8. Hold the curl in place for about
30 seconds (longer for thicker or
naturally curly hair).
9. Unwind carefully, raise the Hair
Clamp to release the hair, and
let the curl cool.
1. Comb through hair and loosen
any tangles.
2. Gather a section of hair
1 inch wide. Make sure that the
section is not too thick or hair
will not curl properly.
CURLING TECHNIQUE
Before Curling:
3. Press the Lever to raise the
Hair Clamp.
Using sections is helpful when
curling hair.
4. Insert the end of the hair under
the Hair Clamp on the side
where the arrows are
1. Begin by sectioning off a "U"
shape at the top crown of the
head and clip.
facing.(Diagram D)
5. Lower the Hair Clamp to secure
the hair against the Barrel.
6. Rotate the handle counter-
clockwise to wind the
hair along the Barrel between
the guides. It is easier if you
support the Reservoir loosely
with the other hand.
5
2. Next, section off each side by
taking a part from the crown
section to the back of the ear
and clip. This divides the front
side from the back of the head.
STORAGE
After use, slide the Power Switch to
OFF indicated by the “0”, unplug
from outlet and allow the Heat-
Ready Dot to change to red. Once
the Iron is completely cooled down,
store in a cool dry place. Do not
wrap cord around Iron.
3. Take the back section and divide
that horizontally from ear to ear
and clip both sections.
4. Within each section take 1-inch
vertical sections. Unclip one
section at a time.
CARE AND MAINTENANCE
Once build-up appears on the Iron,
the unit will have to be cleaned.
Make sure the Iron is off, unplugged
and completely cooled down
before cleaning.
5. Start curling the hair at the back
nape of the neck and work your
way up the back of the head.
Remove the Reservoir, take out the
Reservoir Plug, and remove any
remaining water.
Wipe the Handle, Barrel, and Hair
Clamp with a soft damp cloth.
If the Barrel becomes coated with
hair product residue, the holes for
the steam will become blocked. To
prevent this, use a medium to soft
brush (an old toothbrush works
best) to remove any build-up and
clear out the steam holes. After
loosening the residue, wipe down
with a soft damp cloth.
Caution:
Do not rest Iron on skin.
6. Once the back is finished,
continue on to the sides.
7. The crown of the head will be
the last to be curled. Divide the
crown into 3 vertical sections. It
is easiest to take one long 1-
inch section from part to part,
then divide that into a 1-inch
wide section.
Allow to dry completely before use.
Do not use harsh abrasives,
cleaning agents or solvents.
Do not place Iron in any liquids.
6
REPLACEMENT PARTS
Replacement parts are available, and may be purchased through our
Consumer Relations Department by calling 1-800-934-7455, Mon-Fri.
9am-5pm Central Time, with Visa, Mastercard, Discover, or American
Express. Please be ready to give the part number(s) when you call.
Or log into our website to order at: www.eSalton.com
ANDREW COLLINGE Twirl and Curl™ Spiral Curling Iron (AC8TC)
REPLACEMENT PARTS
PART #
50432
DESCRIPTION
Reservoir with Plug
7
NOTES
8
LIMITED TWO YEAR WARRANTY
Warranty: This Andrew Collinge product is warranted by Salton, Inc. to be free from defects in materials or
workmanship for a period of (2) years from the original purchase date. This product warranty covers only the
original consumer purchaser of the product.
Warranty Coverage: This warranty is void if the product has been damaged by accident in shipment,
unreasonable use, misuse, neglect, improper service, commercial use, repairs by unauthorized personnel,
normal wear and tear, improper assembly, installation or maintenance abuse or other causes not arising out of
defects in materials or workmanship. This warranty is effective only if the product is purchased and operated in
the USA, and does not extend to any units which have been used in violation of written instructions furnished
with the product or to units which have been altered or modified or to damage to products or parts thereof which
have had the serial number removed, altered, defaced or rendered illegible.
Implied Warranties: ANY IMPLIED WARRANTIES WHICH THE PURCHASER MAY HAVE ARE LIMITED IN
DURATION TO TWO (2) YEARS FROM THE DATE OF PURCHASE. Some states do not allow limitations on
how long an implied warranty lasts, so the above limitation may not apply to you.
Warranty Performance: During the above two-year warranty period, a product with a defect will be either
repaired or replaced with a reconditioned comparable model (at our option) when the product is returned to the
Repair Center, or the purchase price refunded. The repaired or replacement product will be in warranty for the
balance of the two-year warranty period and an additional one-month period. No charge will be made for such
repair or replacement.
Service and Repair: Should the appliance malfunction, you should first call toll-free 1 (800) 934-7455 between
the hours of 9:00 am and 5:00 pm Central Standard Time and ask for CONSUMER SERVICE stating that you
are a consumer with a problem. Please refer to model number AC8TC when you call.
In-Warranty Service (USA): For an appliance covered under the warranty period, no charge is made for
service or postage. Call for return authorization 1 (800) 934-7455.
Out-of Warranty Service: A flat rate charge by model is made for out-of-warranty service. Include
$8.00 (U.S.) for return shipping and handling. We will notify you by mail of the amount of the charge for service
and require you to pay in advance for the repair or replacement.
For Products Purchased in the USA, but Used in Canada: You may return the product insured, packaged
with sufficient protection, and postage and insurance prepaid to the USA address listed below. Please note that
all customs duty / brokerage fees, if any, must be paid by you and we will require you to pay the cost of customs
duty / brokerage fees to us in advance of our performing any service.
Risk During Shipment: We cannot assume responsibility for loss or damage during incoming shipment. For
your protection, carefully package the product for shipment and insure it with the carrier. Be sure to enclose the
following items with your appliance: any accessories related to your problem, your full return address and
daytime phone number, a note describing the problem you experienced, a copy of your sales receipt or other
proof of purchase to determine warranty status. C.O.D. shipments cannot be accepted.
To return the appliance, ship to:
To contact us, please write to, call, or email:
ATTN: Repair Center
Salton, Inc.
708 South Missouri Street
Macon, MO 63552
Salton, Inc.
P.O. Box 1637
Columbia, MO 65205-7366
1 (800) 934-7455
E-mail: [email protected]
Limitation of Remedies: No representative or person is authorized to assume for Salton, Inc. any other
liability in connection with the sale of our products. There shall be no claims for defects or failure of performance
or product failure under any theory of tort, contract or commercial law including, but not limited to negligence,
gross negligence, strict liability, breach of warranty and breach of contract. Repair, replacement or refund shall
be the sole remedy of the purchaser under this warranty, and in no event shall Salton be liable for any
incidental or consequential damages, losses or expenses. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
Legal Rights: This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
©2003 Salton, Inc. All rights reserved.
Made in China
P/N 61093A
Printed in China
|